Ready for a New Pair?
German latex. Negative cut. Built to last — if you look after them.
Proper maintenance significantly extends the life of your latex palms by several months, protecting your investment through consistent post-session care.
After Every Session
Step 1
Rinse While Still Wet
Rinse both palms under lukewarm water immediately after use. Do this pitch-side before the latex dries — dried mud is far harder to remove and damages the foam underneath.
↘ Do this pitch-side, not at home
Step 2
Squeeze, Don't Wring
Gently squeeze excess water from the latex — never wring or twist, as this tears the foam cells and permanently reduces grip. Treat the latex like a sponge and press it flat against a clean surface.
↘ Treat the latex like a sponge
Step 3
Air Dry Naturally
Leave palms facing up in a cool, shaded spot for 2–4 hours at room temperature. Avoid radiators, direct sunlight, or storing wet gloves in a bag.
↘ 2–4 hours at room temperature
Step 4
Dampen Before Use
Before kick-off, lightly dampen the palms with water or breathe into them. Dry latex has minimal grip — moisture activates it and restores maximum stickiness instantly.
↘ A small spray bottle works perfectly
Never machine wash
Machine washing destroys the latex palm in a single cycle. The agitation and detergent permanently break down the foam cells. Hand wash only — cool water, no soap.
Storage & Longevity
Do
Use a Glove Bag
Store in a breathable glove bag. Keeps the shape, protects the latex, and stops fingers getting crushed inside your holdall.
Avoid
Heat & Direct Sun
Car boots, sunny windowsills, radiators. High heat causes latex to crack and peel within days — even through the bag.
Do
Keep Slightly Damp
Store with a slight residual dampness. Bone-dry latex cracks over time — not soaking, just not completely arid.